79
14.
Remove the grounding wrist strap from the
printer (if necessary), and reinstall the
printer’s side cover. Don’t tighten the
thumbscrews. Turn on the printer and wait to
see if the control panel shows the “Ready”
message. If it does, turn the printer off and go
on to the next step.
•
If the “Ready” message doesn’t appear,
turn off the printer and remove the cover.
Gently try to rock the ROM card and
SIMMs. If they are inserted correctly, they
should not move. Carry out steps 11, 12
and 13 again, replace the cover and turn
the printer on.
•
If the “Ready” message still doesn’t
appear, and you are confident that you
have installed the ROM card and SIMM
correctly, contact GCC technical support
at 781.276.8620 (U.S. only; outside the
U.S. see back cover),
www.thevirtualprinterstore.com, or your
authorized GCC dealer.
15.
If the printer is ready, tighten the
thumbscrews (at the rear of the side cover)
by hand. Make certain that the printer is
switched off. Reinstall the interface cables
(if necessary, insert the parallel port plug
first).
16.
Turn the printer on again. If the “Ready”
message shows in the control panel, the
physical installation succeeded. Now confirm
the installation and update the printer driver
on all computers that use this printer.
