GC5 iSMA-B-W0202, User Manual, Page: 34 / 43

iSMA-B-W0202 Modbus User Manual
version 1.2 Page 34 / 49
Modbus
Address Dec
Address
Hex
Address
Register name Access Description
30087 86 0x56 SPECIAL INPUT 1 VOLTAGE Read Only expressed in mV.
For current measurements, the formula
for the current:
I =
U
500
where: U – register value,
500 – value of attached resistance
Temperature is expressed in Celsius
degrees * 10
For a result, divide the registry value
by 10:
T =
registervalue
10
Selection of the type sensor is done
using registers from 40151 to 40152
for each input separately
30088 87 0x57 SPECIAL INPUT 2 VOLTAGE Read Only
30095 94 0x5E SPECIAL INPUT
TEMPERATURE 1
Read Only
30096 95 0x5F SPECIAL INPUT
TEMPERATURE 2
Read Only
30103 102 0x66 RESISTIVE INPUT 1 LSB Read Only Special Input measure resistance 1 – 2
(30103-30104, 30105-30106)
Resistance measurement result
expressed in Ω
30104 103 0x67 RESISTIVE INPUT 1 MSB Read Only
30105 104 0x68 RESISTIVE INPUT 2 LSB Read Only
30106 105 0x69 RESISTIVE INPUT 2 MSB Read Only
40134 133 0x85 MODBUS PROTOCOL TYPE Read &
Write
Memory
RS485 Modbus protocol type
0 -> RTU, 1->ASCII
40136 135 0x87 RS485 BAUD RATE Read &
Write
Memory
RS485 baud rate (40136)
40137 136 0x88 RS485 STOP BITS Read &
Write
Memory
Stop bits (40137)
Supported values are 1 and 2
The default value 1
40138 137 0x89 RS485 DATA BITS Read &
Write
Memory
Data bits (40138)
Supported values are 7 and 8
The default value 7
40139 138 0x8A RS485 PARITY BIT Read &
Write
Memory
Parity bit (40139)
The default value is 0 (no parity)
Allowed values:
Value Description
0 (default) none
1 Odd
2 Even
3 Always 1
4 Always 0
40140 139 0x8B RESPONSE DELAY Read &
Write
Memory
Response delay time (40140)
Delay in ms before sending response
The default value is 0.
40141 140 0x8C WATCHDOG TIME Read &
Write
Watchdog time (40141)
Time in second before watchdog reset