Make sure the unit is turned OFF, unplugged and the heating elements of heater are cool
whenever you are cleaning the heater.
Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or
household cleaners as these products will damage the metal trim.
The motors used on the fan and the flame generator assembly are pre-lubricated for extended
bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the
fan/heater and air intake/output vents is recommended.
Any other servicing should be performed by an authorized service representative.
WARNING
: Make sure the power is turned off before proceeding. Any electrical repairs or
rewiring of this unit should be carried out by a licensed electrician in accordance with national
and local codes.
WARNING
: If repairing or replacing and electrical component or wiring, the original wire
routing
color coding and securing locations must be followed.
WARNING
: Electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire
electrical shock and injury to persons.
WARNING
: Do not use this fireplace if any part of it has been under water. Immediately call a
qualified service technician to inspect the fireplace and replace any part of the electrical
system.
WARNING
: Disconnect power before attempting any maintenance or cleaning to reduce the
risk of fire, electrical shock or personal injury.
WARNING
: During any service of this appliance, the power to the unit must be turned off. First
turn off the fireplace. Then remove the electrical plug from the wall outlet.
WARNING
: When the heater is not in use, the heater should be stored in a dry location
away
from possible damage. The power cord should be stored properly to avoid contact with hot or
sharp objects.
Replacing the Remote Control Battery
When the remote control (J) stops operating or its range seems reduced
it is time to replace
the batteries.
1. Open the battery compartment on the remote control (J).
2. Place a new CR2025 battery(not included) into the battery holder with the "+" facing up.
3.Re-insert the battery holder into the remote control (J).
CARE AND MAINTENANCE
16
NOT
FULLY
PLUG IN!
FULLY
PLUG IN!
MAINTENANCE
Reminders
1.
as well as periodic checks and maintenance are necessary to extend the life of this electric
fireplace insert.
2. To avoid the risk of electrical shock, ALWAYS disconnect the power cord from the electrical
outlet before any internal maintenance or replacement of parts in done.
3.Do not zip tie or otherwise bundle the fireplace power cord with other cords when in use.
4.Use caution when opening the metal cabinet of the electric fireplace insert during inspection
and maintenance. If you need replacement parts or have questions regarding the use or
maintenance of this electric fireplace insert lease contact our customer service number at
1-888-878-8820.
5.Make sure plug is fully inserted into the electrical outlet to avoid fire caused by short circuit.
