3.The OFF signal is automatically transmitted to the device
from the remote control (code scan). Once the
device (e.g.
TV
) switches off, immediately
press any key
(except
SET
key) to stop the Automatic
Search.
4.Switch on the device again by pressing the
POWER
key.
Check the function of the other keys on the
remote control. If all the keys do not function (that means you
may not stop the search in time), or most
of keys’ operation is not good enough, you can start the search
again (see steps 2–4) to find out a
suitable code to fit your device completely.
If most of keys’ function properly, that means your setting up
is successful, press the device key (e.g.
TV1
) again to save the code and finish the set up.
Remark:
To abort the Automatic Search, press any key
(except set key). The LED lamp will go out and
the search is terminated. When remote control searches through
all different type of codes, and the LED
will turn off, then the remote control will quit from search
process automatically.
C. Setting up by Manual Search
If setting up with brand name and codes is unsuccessful, you
can also use the
Manual Search
to find the
correct code for operating your device.
1.Switch on the device that you like to control. If it is a video
recorder, insert a video cassette.
2.Point the remote control at your device. Press down and hold
the
SET
key and press the device key (e.g.
TV
) in a short time (less than 3 seconds, otherwise it goes to
Automatic Search), then release the both
keys pressed.
3. The LED will be on at the moment and the remote control is
then in setting-up mode.
4.Actuate the
POWER
key (ON/OFF key) about every 2
seconds. (If the device being sought is a video
recorder, DVD player, CD player, AUX etc., you can press the
PLAY
button also.), the device button
now flashes, that means it is in Manual Search mode.
5.Once the searched device switches off (or react), test the
functions of other keys (don’t press POWER
key, in case it goes to next code) on the remote control. If most
of them do not function properly, press
the POWER key about every 2 seconds again to search the next
reactive code (continues the Manual
Search, see step 4-5).
Summary of Contents for Puma
Page 1: ......
