10
NEOSERV 114
gbo Medizintechnik AG 2004
Version 1.5
3 Description of function
3.1 Power Switch and Fuse Unit
If the power switch is set to the „0“ position, the unit is completely cut off from mains. The unit is turned on
by toggling the switch to the „I“ position. Moreover, the connector socket assembly also contains the mains
fuses. The green LED of the
Standby key
will be flashing.
3.2 POWER
ON
Upon switching on the unit, the green LED will be flashing. After pressing the
Standby key
the LED will lit
constantly. This signals that the unit is ready for operation.
3.3 Overtemperature
The system constantly monitors pump temperature. In case of overheating, the pump will be automatically
switched off, and the LED will be flashing.
3.4 Water
Level
If the water level within the water separator is too high, the red water level indicator LED will be flashing.
The water must be emptied with the hose on the back side of the unit.
1. Provide a suitable container for the sewage.
2. Switch off the
NEOSERV 114
.
3. Take off the hose out of the upper side of the back panel.
4. Drain all liquids into the sewage container.
5. Switch on the
NEOSERV 114
.
6. Press
the
Standby key
and keep him pressed for more than 5 seconds.
!!
Note!
The vacuum pressure indicator flashes, i.e. the
NEOSERV 114
is in the cleaning mode.
7. The pump will press all liquids out of the water separator.
8. Switch off the
NEOSERV 114
or press the
Standby key
.
9. Fasten the hose on the upper side of the back panel.
10. Start with the next treatment.
