GBF SentryLink, Installation Manual

Page: 3 / 17

CONTENTS
(1) GBF Smart IP Video Door Station (GBF-SKT001)
(1) Metal Back Box
(1) 12VDC 3A Power Adapter
(2) 5-pin Unlock Relay Wire Harnesses
(4) Screws with Anchors
(1) Installation and Instruction Manual
- Choose a location for your new SentryLink Door Station, taking into
consideration sightlines, shadows, and excessive background lighting for
the camera. Optimal mounting height would be approximately
60” (150cm)
from the surface that the caller would be standing on to the camera lens.
- Confirm the following available connections are available at the installation
location: Live internet feed (RJ45 plug), mains power or low voltage extension
wire, door or gate control wire(s), and optionally push to exit button
connection(s) (See Fig.1 below for the connection port layout for this system).
-
Feed the power supply wiring, wiring harness(s), and internet cable through
the hole from the back side of the back box. Use the six screws (and anchors,
if required) supplied to mount the back box to the wall in the desired location.
* For a flush-mount backbox, be sure that all of the edges of the backbox
are flush to or slightly proud of the surrounding building finish. The edges
of the SentryLink Door station are slightly larger than the backbox
dimensions, and the edges seal tightly to the backbox when the cam
locks and set screws are engaged.
- Connect wiring harness and other connections to the back of the IP
Doorbell. Gently use the provided cam lock key to lock the device in to the
back box.
-
Secure the IP Doorbell into the back box at the bottom leading edge
using the two supplied Hex-Head screws and Allen key.