OPERATING INSTRUCTIONS
4.3
Debinding
1. Place document to be debound as follows: bound edge against the backstop,
small hole in bottom strip over locating pin, edge of document next to bind edge
guide.
2 Once the document to be debound is properly located, depress the Bind/Debind
selector to place machine in debind mode.
3 Lower the pressure bar onto document, and the machine will go through the
debinding cycle.
5. Immediately after pressure bar raises (approximately 12 seconds), remove the
document and peel the top strip off.*
*NOTE: If you do not perform this step quickly enough, it will be too difficult
to remove the strip. Put the document through the debind process again and
remove the strip faster this tim e.
Figure 4-2
4-3
