GBC Laminator, Operation And Maintenance Manual

Page: 17 / 46

F-60 Operation and Maintenance Manual Installation
© GBC Pro-Tech 1998 July 2-5
☞
A NOTE ABOUT RECYCLING
The crate components can be reused for shipping the
machine again, or can be disassembled and the wood
and screws recycled. The shrink wrap is not recyclable,
however, so it must be discarded.
14. Level the laminator using the procedure later in
this section.
6HWXS
Once the F-60 Laminator has been unpacked and
moved into final position check each of the following
items.
Tools required:
•
1
/
8
" hex wrench
• Adjustable wrench
Setup Procedure:
1. Inspect the laminator for any obvious shipping
damage.
2. Using a
1
/
8
" hex wrench, remove the screws secur-
ing the cabinet panel to the control (electrical) side
of the machine.
3. Using a
1
/
8
" hex wrench, remove the screws secur-
ing the cabinet panel to the drive side of the
machine and rotate the panel around the clutch
knob.
4. Inspect all the bolts and tighten any that were loos-
ened during shipping.
5. Set the nip. (See Maintenance for the procedure.)
6. Replace both cabinet covers.
/HYHOLQJ
Tools required:
• Adjustable wrench
• Carpenter's level
To level the laminator:
1. Raise each end, remove the castors and install a
leveling pad and stud onto each of the foot brackets
at the four bottom corners of the laminator. Thread
third nut on stud above foot bracket.
2. Thread stud into 4 leveling pads lock down with
nut. Thread second nut onto stud.
3. Place a carpenter's level front to rear across the two
lower tie bars at one end of the machine.
4. Level this end of the machine front to rear, raising
or lowering the leveling pads by adjusting the mid-
dle nuts on the foot bolts.
5. Move the level to the other end of the machine and
level front to rear.
6. Place the level directly on one of the tie bars and
level the machine side to side.
7. Recheck the front to rear level condition to insure
that it has not changed. If it has, repeat the leveling
procedure.
8. When all the measurements indicate that the
machine is level, tighten down the top nuts on the
foot brackets to lock the pads in their current posi-
tion.