Operation, hot lamination
1
2
3
4
5
6
Operation, cold lamination
Laminating Tips
Connect power cord to appropriate power source.
To use the laminator:
For Plus A4:
Switch the temperature button to “HOT”
position and
the power button to “ON”
(I) position . The
power indicator will glow.
For Plus A3:
Switch the power button to “HOT”
(II)
position (fig. 1). The power indicator will glow.
Position the document to be laminated into a GBC
laminating pouch, so that the document is aligned to the
folded sealed edge and the right and left borders are equal
(fig. 2).
When the ready indicator glows (fig. 3), insert pouch with
the sealed edge first into the machine (fig. 4).
The laminated item will automatically exit rear of the
machine. After the pouch has stopped moving,
immediately place it on a flat surface to cool for one
minute before handling.
If you have finished laminating, switch the power button to
“OFF” (O) position (fig. 1).
NOTE: DO NOT LAMINATE AN EMPTY POUCH.
C
onnect power cord to appropriate power source.
To use the laminator:
For Plus A4:
Switch the temperature button to “COLD”
position and
the power button to “ON”
(I) position . The
power and ready indicator will glow.
For Plus A3:
Switch the power button to “COLD”
(I)
position (fig. 1). The power and ready indicator will glow.
U
se and laminate your cold pouch.
CAUTION: If you have just done hot lamination,
please wait at least 30 minutes for the machine to
cool down before attempting to do cold lamination.
In the event of a misfeed or a jam follow these instructions.
• DO NOT LAMINATE AN EMPTY POUCH.
• Never insert the loose end of the pouch into the machine
first. This could cause the machine to jam.
• Before laminating important or unique documents, always
run a test pouch through the laminator using a similar type
of document.
• Do not attempt to do single sided lamination. This will
destroy the laminator.
• As soon as hot lamination is completed, remove the
lamination from the front of the machine and place on a cool
flat surface for cooling to prevent the pouch from curling.
• Do not block the vent slots, this will cause the laminator to
overheat.
• Do not cut pouches prior to lamination.
Service
Do not attempt to service or repair the pouch laminator
yourself. Unplug the unit and contact an authorised ACCO
Brands service representative for any required repairs.
Cleaning
WARNING: UNPLUG THIS PRODUCT
BEFORE CLEANING THE EXTERIOR.
WIPE EXTERIOR ONLY WITH A
DAMP CLOTH AND DO NOT USE
DETERGENTS OR SOLVENTS.
Release Button
Turn off the laminator immediately.
Press the release button to release the motor from the
rollers. Pull out your document from the front of the
laminator while pressing the release button left.
(fig. 5).
Clean the rollers as described in the cleaning section.
The laminator will be ready to use again within seconds.
NOTE: DO NOT LAMINATE AN EMPTY POUCH.
CAUTION:
Be careful when removing the
laminated pouch from the machine. It may be hot.
1
2
3
1
2
1
2
3
4
Adhesive may exit the pouch and stick to the rollers while
laminating or if a jam occurs. Regularly feed a cleaning card
or sheet of paper through the laminator to clean the rollers.
Run the cleaning card or sheet of paper through the
machine two or three times.
Turn off the machine when finished laminating and
cleaning.
Summary of Contents for Inspire Plus A4
Page 1: ......
