GBC fusion 1100L, Instruction Manual

Page: 6 / 76

GB
6
register this product online at
www.accoeurope.com
getting ready to laminate
Easy Set Up
1
Take the electrical plug and place in an appropriate power source which is near the table you
intend to use
2
The laminator will respond with a single beep and a sequence of brief ashes across the control
panel
3
To use the laminator move the slider to the right from the to the mic or mic position
depending on which pouch selected Below the slider you will see a white line this indicates that
you have switched the laminator on
loading the pouch
1
Take your item to be laminated and place in to the appropriate sized laminating pouch
ensuring it is rmly located along the sealed edge This is to help ensure that you get optimal
quality output
Before laminating important or unique documents always run a test pouch through
the laminator using a similar type document
SEALED EDGE
A3, A4, A5, etc. Irregular shaped item
SEALED EDGE
NOTE: Do not cut pouches prior to
lamination
a b
NOTE:
Your new laminator may emit a slight
odour during the initial operation Its
is normal and will diminish after a few
hours of operation
NOTE:
only use micron micron
micron or micron pouches with
this laminator
Visual & Audible Ready Alerts
4
The laminator will start to warm up an orange light will be illuminated to the right of the
‘ ’
a
When the laminator is ready to use the green light next to the
‘tick ’
is illuminated b and a
series of two beeps are heard