© 2019 ACCO Brands|All rights reserved. No part of this document may be reproduced or modified in
any form or by any means without prior written permission of ACCO Brands. GBC® and Foton
™
30 are
registered trademarks of ACCO Brands Corporation.
Status Indicator
Red Continued:
Cutter Error Indicator Red
Continued:
the cutter. If the cutter works Re-insert your cartridge. Might
need to trim off the leading edge of film where the cutter
jammed. If you need to trim the film leave 4 inches (100mm)
of sealed film as the cartridge leader. Re-insert the cartridge.
The machine once warmed-up will automatically thread the
film and activate the trimmer.
If the cutter does not work after the above steps contact GBC customer
service for warranty repair.
Film Wrinkles on
output
Film Misaligned
Press and hold the RUN button to manually advance the film. After 5
–
20 inches (125
–
500mm) of film has been advanced the wrinkle should
work themselves out. If wrinkle clear press the manual cut button and
you are ready to begin.
If wrinkles still present, open the laminator door. Grasp the film exiting
the laminator and hold it Taut while closing the laminator door. Repeat
above step and wrinkles should disappear.
Film Edges are not
evenly aligned.
Top and bottom rolls of
film are not matched
properly.
Press and hold the RUN button to manually advance the film. After 5
inches (125 mm). Grasp the film exiting the laminator and hold it Taut
while closing the laminator door.
Documents are
skewed in the film
when exiting
Documents fed in skewed
Before loading paper, try tapping the leading edge of the paper on a flat
surface and then repeat with the bottom or top edge to get your paper
properly squared.
Insert your media in the auto feeder and slide the edge guide up to edge
of your media.
Experiencing
frequent double
feeds
Paper has heavy static
Try fanning the media or placing in a paper jogger prior to feeding it. If
issues persist use the Manual Feed / Auto Cut mode.
Experiencing
frequent mis-feeds
Rollers are slipping on
media and do not feed
sheets
Try fanning the media or placing in a paper jogger prior to feeding it. If
issues persist use the Manual Feed / Auto Cut mode.