GBC Falcon 60+, Operation Manual

Page: 19 / 41

Operations Manual
Page 18
©2004 General Binding Corporation
FALCON
60+ (-1)
CE
Fig 8
Fig 9
(1)
(2)
(E)
Fig 10
For items 5 -13, refer to Figure 8.
5. SPEED : This means machine roller speed. Turn
clockwise to increase speed or counterclockwise to
decrease speed. Speed range is 1 - 10.
6. TEMPERATURE CONTROLS: The upper and lower
heaters have identical controls, on, off, increase,
decrease and measure. The top set of controls relate
to the upper heater ( ) and the lower set of controls
relate to the lower heater ( ).
7. TEMPERATURE CONTROL ON :
When pressed,
indicator illuminates and turns power on to the tempera-
ture controller unit.
8. TEMPERATURE CONTROL OFF :
When pressed,
turns power off to the temperature controller unit.
9. TEMPERATURE INCREASE :
When pressed,
increases the temperature set point value.
10. TEMPERATURE DECREASE :
When pressed,
decreases the temperature set point value.
11. TEMPERATURE MEASURE:
When pressed, flashes
the actual temperature of the roller.
12. COOLING ON :
When pressed, indicator illumi-
nates and turns on the cooling fans.
13. COOLING OFF :
When pressed, turns off
the cooling fans.
D. E-STOP:
Four emergency stop buttons exist on the
laminator. Two located on the left and right front and two
on the left and right rear of the laminator. (Figure 9)
To engage, push (1) any emergency stop push button.
Power to the motor is removed. To disengage, turn (2) the
push button 1/4 turn counterclockwise.
E. SAFETY SHIELD INTERLOCK LATCH:
(Figure 10)
Used to lock the safety shield into position and activate an
interlock switch. The interlock latch is located on the left
side of the safety shield. When pushed to the full left (1),
the safety shield is locked. When pushed to the full right
(2), the safety shield is unlocked.