![background image](http://html1.mh-extra.com/html/gbc/f/f_operation-and-maintenance-manual_570945016.webp)
Installation
F-60 Operation and Maintenance Manual
2-4
© GBC Pro-Tech 1998 July
4. Carefully remove the accessory pack from the skid.
The accessory pack should contain:
1 Set, hex wrenches
1 Slitting knife
1 Manual
1 Set, spare fuses
1 Roll of masking tape
1 100% cotton terry cloth
4 Leveling pads
5. Place the foot switch on the pull roll cover to pre-
vent the foot switch wire from damage during
removal of the machine from the skid.
WARNING
6. The machine is supported above the skid by resting
on a support saddle under each end of the machine.
Remove the three long two by fours that attach to
the support saddles.
7. On one side of the machine, remove the lag bolts
holding the support saddle to the skid.
8. Using two of the two by fours as levers, carefully
lift the end of the machine enough to allow the sad-
dle to be removed from the skid and the machine to
rest on its wheels.
9. Repeat Steps 7 and 8 for the other end of the
machine.
10. The ramps included with the laminator can be
secured to the edge of the crate bottom using the
screws left over from the crate disassembly (see
Figure 2-2).
11. Have the machine moved off the skid and placed
on the floor by licensed riggers.
Roll the machine off by securing included ramps to
the edge of the crate bottom using the screws left
over from the crate disassembly (See Figure 2-2).
Lift the machine off by applying fork lift truck
blades to the two bottom tie bars between the cabi-
nets. The fork lift blades must be located at the lift
label locations on the tie bars (see Figure 2-4).
Figure 2-4:
12. Remove any plastic strapping and packing paper
taped to the
roll
s.
CAUTION
13. Remove all packing materials to a safe distance
from the laminator.
Do not attempt to move the laminator across
anything other than a flat, level surface without
trained and qualified riggers. You can be crushed
or seriously injured. Steps 6 through 11 should be
completed by LICENSED RIGGERS ONLY.
The F-60 Laminator is a large and heavy piece of
equipment. It is necessary to employ LICENSED
RIGGERS ONLY to move the machine.
GBC Pro-Tech bears no responsibility for
personal injury or damage due to moving the
laminator improperly.
Do not use a knife or other sharp instrument
during installation or while servicing the
laminator. You can cause irreparable damage to
the rolls.
WARN
IN
G
AC
HTUN
G
MI
SE
EN
G
AR
DE
WA
RN
IN
G
AC
HT
UN
G
MI
SE
EN
G
AR
DE
PR
O-T
EC
H
F-6
0™
CAL
320
0
2
100
90
80
70
60
50
40
30
20
10
1
2
3
4
5
6
7
8
9
10
CAL
320
0
Fork Lift Label
Locations
Summary of Contents for F-
