Page 6-9
Operating Instructions
27C
To run the first pass:
Load the laminator as shown in Fig. 16.
Adjust the roller pressure handle to the proper
laminating setting.
Place the item to be laminated on the feed table,
then press
RUN
.
Guide the item into the rollers.
Once the item has cleared the back of the
machine, press
STOP
.
Remove the web and trim out the encapsulated
item.
To run the second pass:
Unweb (unload the films) the laminator before
running the second pass.
Fig. 6-16. Laminator Ready for Mounting.
Adjust the roller pressure handle to the proper
mounting setting.
Set the motor speed to
min.
Peel back the leading edge of the release liner
of the laminated item approximately 4 inches (10
cm).
Place the item on the mount board.
Tack the exposed adhesive edge of the item,
from the center out, to the leading edge of the
board.
Be sure to not introduce wrinkles or air bubbles.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
Butt the leading edge of the board up against the
rollers.
Drape the encapsulated item over the safety
shield.
Do not allow the print to flop backwards.
Press
RUN
and immediately grasp the release
liner for separation as the board is pulled into the
rollers. Do not allow the release liner to be pulled
into the rollers.
After the board has cleared the rollers press
STOP
.
6.
7.
8.
9.
Release liner
Print over safety shield
Summary of Contents for 27C
