5
EN
●
Installing or Removing Depressed Center Wheel
Screw the inner flange onto the spindle, then put
the wheel into the spindle and install it on the inner
flange, and screw the outer flange to the spindle.
Press the spindle lock device to prevent the spindle
from rotating. Then use the lock nut wrench to tighten
the outer flange.
CAUTION:
Always be sure that the tool is switched OFF
and unplugged before installing or removing the
accessory.
1.Outer Flange
2.Depressed
Center Wheel
3.Inner Flange
4.Drive Spindle
1
2
3
4
●
Spindle Lock
Press the spindle lock to prevent spindle rotation when
installing or removing the accessory.
CAUTION:
Never actuate the spindle when the spindle is
moving. The tool may be damaged.
Model
GM4570
GM4590
Rated Power Input
W
2200
2200
Rated Speed
/min
8300
6600
Wheel Size
mm
Ø180x8xØ22
Ø230x8xØ22
Wheel Type
Type 27
Type 27
Net Weight
kg
5.0
5.0
※
Due to the continuing program of research and development, the specifications herein are subject to change
without prior notice.
Technical Data
This product is a hand-held angle grinder powered by single phase series motor.
This product is suitable for grinding metal materials with fiber-reinforced depressed center wheel under general
environmental conditions.
This product is widely used in the processing of metals and building materials.
The performance and specifications of this product are shown in the table below:
INSTRUCTIONS FOR OPERATION
●
Installing or Removing Wheel Guard
The wheel guard must be installed during
operation!
Use the wheel guard, a protective device, to
prevent injury caused by the rupture of the wheel
during operation. Make sure that the wheel guard
is installed securely before use. After loosening
the fixing screws slightly, the wheel guard can be
rotated and fixed at the required angle to obtain
the maximum working efficiency. After adjusting the
wheel guard, it is necessary to confirm whether the
fixing screws are fully tightened.
CAUTION:
Always be sure that the tool is switched OFF
and unplugged before installing or removing the
wheel guard.