Gazelle GM4010, User Manual, Page: 6 / 12

6
EN
CAUTION:
Always be sure that the tool is switched OFF
and unplugged before installing or removing the
accessory.
1.Outer Flange
2.Depressed
Center Wheel
3.Inner Flange
4.Drive Spindle
1
2
3
4
● Spindle Lock
CAUTION:
Never actuate the spindle lock when the drive
spindle is moving to avoid damaging the tool.
Press the spindle lock to prevent spindle rotation
when installing or removing the accessory.
1.Spindle Lock
1
● Switch Operation
1.ON
Model GM4010
GM4520
GM4520C
Rated Power Input W 800 800
Rated Speed /min 13000 11800
Wheel Size mm Ø100x4xØ16 Ø115x4xØ22
Wheel Type Type 27 Type 27
Net Weight kg 1.5 1.5
※ Due to the continuing program of research and development, the specifications herein are subject to change
without prior notice.
※ Illustrations,figures and photos may vary slightly due to program of continuous product improvements,
please in kind prevail.
Technical Data
This product is a hand-held angle grinder powered by single phase series motor.
This product is suitable for grinding metal materials with fiber-reinforced depressed center wheel under general
environmental conditions.
This product is widely used in the processing of metals and building materials.
The performance and specifications of this product are shown in the table below:
INSTRUCTIONS FOR OPERATION
● Installing or Removing Wheel Guard
The wheel guard must be installed during operation!
Align the protrusion on the wheel guard clamp with
the notch on the bearing box. Then rotate the wheel
guard 180 degrees clockwise. Be sure to tighten the
screw securely.
To remove the wheel guard, follow the installation
procedure in reverse.
CAUTION:
Always be sure that the tool is switched OFF
and unplugged before installing or removing the
wheel guard.
● Installing or Removing Depressed Center
Wheel
Screw the inner flange onto the spindle, then put
the wheel into the spindle and install it on the inner
flange, and screw the outer flange to the spindle.
Press the spindle lock device to prevent the spindle
from rotating. Then use the lock nut wrench to
tighten the outer flange.