Gazelle Easyflow HMS, User Manual

Page: 126 / 480

58
Easyflow HMS
6.3.1 Shimano W-indications
Code Problem Situation Remedy
W101
(W011) Speed not indicated. The maximum speed up to
which assistance is given
will be lower than normal. Ask your Gazelle service specialist to carry out the following:
•
Check whether the speed sensor has been mounted in
the correct position.
W103
(W013) Initialisation has not been
properly completed for the
sensor of the tightening
torque. The assistance will be less
than normal. Press the on/off button of the battery (without standing on the
pedal) to activate the power again.
W104 Leakage detected in the
system and power output
was switched off. No assistance will be given
while cycling. Ask your Gazelle service specialist to carry out the following:
Remove all parts one by one, apart from the drive unit, and
switch the power back on
•
If the part with a problem was not removed the power will
switch off when starting up.
•
If the part with a problem was removed, the power will be
activated and W104 will remain on the screen.
W105 Unexpected power failure
detected. -- Consult your Gazelle service specialist (or the ‘Shimano
STEPS user manual’ and switch the power off and then back
on again.
If W105 appears often on the screen, ask your Gazelle ser-
vice specialist to carry out the following.
•
Check whether the battery holder is rattling or whether
the power cable is disconnected