4.
Safety recommendations and warnings
Warning! Carefully read the warnings below before using or working with the product!
•
Always adhere to the local rules and regulations when installing or using the remote reflector.
•
When used in combination with an electronic ballast, this product may cause interference to radio equipment. It should
not be installed near maritime safety communications equipment or other critical navigation or communication equipment
operating between 0.45 - 30 MHz.
•
Do not use the remote reflector when the lamp cord is damaged. Replace the lamp cord only with original certified cords.
•
Replace the lamp only with lamps specified by Gavita. The use of other lamps may damage the product and lamp and will
void the warranty.
•
Do not expose the remote reflector to:
-
condensing humidity, heavy mist, fog or direct spray;
-
(ambient) temperatures outside the specified range;
-
dust and contamination;
-
direct sunlight during use or artificial light that could heat up the ballast.
•
Always disconnect the product from mains before performing any maintenance.
•
Always allow for a cool down period of at least 30 minutes before touching the lamp or reflector. Touching the lamp or the
reflector when the lamp is lit or immediately afterwards will result in severe burns!
•
Never touch the lamp with bare hands as this will cause damage to the lamp.
•
Do not use the remote reflector above flammable, explosive or reactive substances. The lamp and the reflector of the
remote reflector reach temperatures of >85 °Celsius / >185° Fahrenheit.
•
Do not use sulfur vaporizers or water misters. Sulfur and calcium deposits on your reflector will decrease its efficiency.
•
The installation and use of the remote reflector is the responsibility of the end user. Incorrect use or installation can
lead to failure and damage to the remote reflector. Damage to the remote reflector and electronic circuitry as a result of
incorrect installation and use revokes the warranty.
5.
Contents (1)
A.
Gavita HortiStar 1000 DE EU/US
1. Connector box
2. Reflector bracket
3. Lever to unlatch reflector
4. Lamp socket
5. Reflector Gavita HR96 DE*
*The reflector is delivery dependent,
it may differ from the image
6. Mounting points
7. US:
Lamp cord with XM01 connector 13 ft
*EU:
Lamp cord with Wieland RST20i3
connector 4m
(*For EU models a lamp cord is delivery
dependent)
6.
Controls, connections and
indications (2)
A.
Connection terminal
B.
Cable gland
A6
A1
A6
A3
A5
A4
A2
A6
A1
A6
A3
A5
A4
A2
A6
A7
1.
B
A
B
A
2.
Wieland RST20i3
XR601 / XM01
Gavita HR96 DE
Gavita M 110
DE SR
Gavita W
150 DE
