10.2.
Placement and replacement of the reflector
Note:
Gavita recommends replacing the reflector after 10000 lighting hours.
Depending on the environment and contamination levels the reflector will degrade.
The vega/Miro™ aluminum can be cleaned with soapy water, but we recommend to
change the reflector every two to four years. Also replace the lamp when replacing
the reflector.
•
Switch off mains power.
•
Remove the lamp from the fixture (see paragraph 10.1).
•
Support the reflector on the side of the reflector lever to prevent it from falling
(11).
•
Move the reflector lever up to retract the two pins holding the reflector in place
(12).
•
Remove the reflector (13).
•
Place the new reflector. Ensure the reflector lever is in the opened position to
allow the reflector to pass.
•
Ensure the holes in the reflector are aligned with the pins in the fixture (14).
•
Release the reflector lever so its two pins hold the reflector in place.
•
Insert the lamp in the lamp holder (see paragraph 10.1).
•
Switch on mains power.
11.
Storage and disposal
•
Store the fixture in a dry and clean environment, with an environmental
temperature of -20 ~ 85 °Celsius.
•
The product must not be discarded as unsorted municipal waste, but must be
collected separately for the purpose of treatment, recovery and environmentally
sound disposal.
Caution!
The lamps are chemical hazardous waste and must be delivered to the
designated authorities.
Caution!
The lamp contains mercury.
12.
Warranty
The warranty conditions are delivery dependent and can be found on a separate
sheet.
10.
11.
12.
13.
