CPR SUSIE®
|
User Guide
Troubleshooting | 71
9.3 OMNI® OR OMNI®2 IS NOT DETECTING ANY
COMPRESSIONS OR VENTILATIONS
Probable Cause
Solution
System is not calibrated
Calibrate compressions and ventilations using the
calibration menu (CALIB). The CALIB menu is found
on the main screen or in the MORE menu.
Probable Cause
Solution
Reset the compression sensor
Tap the menu icon, then tap on “Reset
Compressions Sensor”
Reset the ventilations sensor
Tap the menu icon, then tap on “Reset Ventilations
Sensor”
9.5 CPR IS NOT DETECTED IN OMNI®2
Review the OMNI®2 user guide for the most common trouble shooting topics regarding the OMNI®2 tablet.
9.4 OMNI®2 TAKES TOO LONG TO BOOT UP
Probable Cause
Solution
A system restore is required
1. Unplug the communication cables from OMNI®
2. Press and hold down the two outer keys
located on the right side of the tablet, while
reconnecting the communication cable.
3. Once the “please wait” message appears on
the screen, release the two outer keys.
4. Wait for the main screen to load and
continue with simulations.
Summary of Contents for CPR SUSIE S306
Page 2: ......
