NYLOCK NUT
#8-32
FLAT WASHER
0.188"X0.781"
MACHINE SCREW
#8-32 X 7/8"
OR
OR
OR
1999
–
2016, Ford Super Duty
Rear Mount Bracket
Mounting Diagram & Instructions
GB 755007
IMPORTANT:
The manufacturer is not responsible for negligent use of vehicle with mud flaps installed, including
over-tightening of screws and bolts causing damage to vehicle or mud flaps
.
TOOLS REQUIRED:
½” or 3/8” drill #2 Phillips 3/8” socket driver
5/16” wrench 1/8“ drill bit Clamp 11/32” wrench 3/8” wrench
screwdriver & 5/16” socket driver or socket wrench
or socket wrench or socket wrench
BRACKETS:
(1)Mount Bracket,
(1)Mount Bracket
(1) LH Bracket
(1) RH Bracket
Rear, LH
Rear, RH
Part #750136
Part #750137
Part #755129
Part #755130
PARTS BAG #755137
a) (4) Machine Screw
b) (4) TEK Screw
c) (4) TEK Screw
d) (6) Machine Screw
#10-24x1”
¼ x1 ¼
#10 x 1”
#8-32 x 7/8”
Part #012022
Part #010011
Part #010009
Part #012025
e) (4) Flat Washer
f) (4) Flat Washer
g) (8) Half Washer
h) (6) Flat Washer
0.281 x 1”
0.203 x 1”
0.203 x 1”
0.188” x 0.781”
Part #018028
Part #018031
Part # 018032
Part #018018
i) (6) Nylock Nut
j) (4) Hex Nut
k) (4) Lock Washer
#8-32
Part #025003
#10
Part #025005
Part #024001
INSTALLATION
For ease of installation, it is suggested that the wheel be removed.
1.
Fasten the LH mount bracket to the left hand flap with 3 machine screws / small washers and nylock
nuts to Holes #1, #2 and #3 or if you prefer the flap mounted higher and farther away from the ground
then use Holes #4, #5 and #6.
See Diagram #1.
2.
Bolt the LH bracket to the LH mount bracket of the LH mud flap assembly on holes #9 and #10
with machine screws/half washers/ washers/lock washers/hex nuts.
(See Diagram #2.)
Loosely
secure at this point.
3.
Push the flap up against the wheel well and raise the flap assembly until the LH bracket is up
against the bottom of the truck box frame.
See Diagram #2.
4.
Fasten the flap with 2 TEK screws and 2 flat washers on holes #7 and #8. Loosely secure
at this point. It is a good idea at this time to temporarily reinstall the tire in order to square the flap.
.
Push the LH bracket toward the back until the flap is parallel to the tire and then drill two 1/8” pilot
holes from the center of the slotted holes on the LH bracket through the box flange and tighten
with #10 TEK screws and half washers. Tighten remaining screws.
Check all fasteners for tightness. Repeat procedure on the other side.
Diagram #1
