B
Tighten clamps securely on
side rails before driving vehicle.
WARNING
LEVEL
B
Repeat steps 3-5 on passenger side for item C. Proceed to step 7 when complete.
1/2”
Adjustment Zone
Cover tension is controlled by four position adjustable blocks.
To start, place blocks in postion shown below. With 4 on top and
closest to front header. Secure blocks with hitchpin in #2 hole,
this is the least amount of tension. (Position 4)
Hitchpin
Position 1
Maximum
Position 2
Position 3
Position 4
Minimum
Setting cover tension
1. Set cover tension during warmest part of the day.
2. Roll cover up to adjustable block.
3. Pull Hitchpin and rotate blocks to the next position need-
ed. Replace Hitchpin.
(Driver and passenger blocks
must always be in the same position.)
4. Close cover and re-check adjustment. Repeat until
satisfactory tension has been achieved.
4
5
6
7
With Tailgate Closed, Position Side Rail Compressing End Seals Equally Between Cab and Tailgate.
End Seal Compressed
At Tailgate.
End Seal Compressed At Cab.
GATOR ETX SOFT ROLL UP TONNEAU COVERS, 2303 SE 17TH ST, SUITE 102, OCALA, FL 34471
3
SETTING TENSION ADJUSTMENT BLOCKS
When installing clamps, finger tighten nut holding back side of clamp. Be sure the teeth of
the clamp engage with the grooves of the side rail. Hold the clamp firmly with one hand
to tighten the bolt. Avoid twisting or
rotating the clamp during this process.
