Instructions for GK SERIES
www.gatexpertstore.com
14
LE
D 2
AN
1
Setting and Debugging of Control Box
After confirming the wiring, turn on the power for the debugging of next step (the
following debugging steps can be applied to both single phase and three phases
control box):
a. Remote control learning:
①
Press the black button AN1 on the circuit
board, LED2 indicator light flickers, then
press any button of transmitter (usually
Button 1), LED2 indicator light flickers again,
and then press the same button of transmitter,
LED2 indicator light will be strobe for 4 seconds and later off. The learning of the
remote control is finished.
②
As for the learning of the other remote control, repeat the above steps. The same
control panel can learn up to 25 remote controls.
③
There are two modes for remote control: Three Button Mode and Single
Button Mode. Please decide one of the two modes mode when ordering.
Three button mode remote control: OPEN/CLOSE/STOP of main engine are controlled by
three buttons separately on the remote control.
Single button mode remote control: OPEN/ STOP/CLOSE of main engine are controlled by
one button circularly on the remote control.
Note:
Three button mode remote control:
As long as the "Button 1" is learnt, the entire remote
control learning can be completed.
Single button mode remote control:
The four buttons on the remote control can be paired
to four different motors, each button for one motor.
