Venice Single Board Computer Operating Manual
Mini-PCIe (J8 & J10)
The PCI Express Mini Card socket is an industry standard form factor.
● Slot 8 Supports PCIe and USB 2.0.
● Slot J10 can support PCIe and USB 2.0 and SIM.
Pin
Signal
Connect
Pin
Signal
Connect
1
WAKE#
No Connect
2
3.3VAUX
3.3V
3
COEX1
No Connect
4
GND
Ground
5
COEX2
No Connect
6
1.5V
No Connect
7
CLKREQ#
No Connect
8
USIMPWR
Note 2
9
GND
Ground
10
USIMDAT
Note 2
11
REFCLK-
REFCLK-
12
USIMCLK
Note 2
13
14
USIMRST
Note 2
15
GND
Ground
16
USIMVPP
Note 2
17
RSVD
No Connect
18
GND
Ground
19
RSVD
No Connect
20
WDIS#
No Connect
21
GND
Ground
22
PERST#
Note 3
23
PERN0/SATA+B
Note 1
24
3.3VAUX
3.3V
25
PERP0/SATA-B
Note 1
26
GND
Ground
27
GND
Ground
28
1.5V
No Connect
29
GND
Ground
30
SMBCLK
No Connect
31
PETN0/SATA-A
Note 1
32
SMBDAT
No Connect
33
PETP0/SATA+A
Note 1
34
GND
Ground
35
GND
Ground
36
USBD-
Note 4
37
GND
Ground
38
USBD+
Note 4
39
3.3VAUX
3.3V
40
GND
Ground
41
3.3VAUX
3.3V
42
LEDWWAN#
No Connect
43
GND
Ground
44
LEDWLAN#
No Connect
45
RSVD
No Connect
46
LEDWPAN#
No Connect
47
RSVD
No Connect
48
1.5V
No Connect
49
RSVD
No Connect
50
GND
Ground
51
RSVD
No Connect
52
3.3VAUX
3.3V
Mini-PCIe Socket
Software Programmable RS232/422/485 Serial Port (J11)
A RS232/422/485 serial port is available through a 5-pin header in a 1x5 configuration
with 2mm spacing. The mating connector is a JST PAP-05V-S, available from Digi-Key
as part number 455-1489-ND. The mating connector pins are JST SPHD-002T-P05,
available from Digi-Key as part number 455-1313-1-ND.
● GPIO[4]:DIO[0] selects between RS232 and RS485
○ 0 = RS232
○ 1 = RS485
● GPIO[1]:DIO[0] selects UART_TERM (RS485 Termination)
○ 0 = No termination for RS485
○ 1 = 120 Ohm termination for RS485 RX and TX
● GPIO[4]:DIO[2] selects UART_HALF ( RS485 Half or Full Duplex)
○ 0 = Full Duplex for RS485
GATEWORKS.COM 3026 S. Higuera St San Luis Obispo, CA 93401
P:(805)781-2000
21 of 32