Gateway MX6708, Hardware Reference Manual

Page: 45 / 72

Replacing the hard drive kit www.gateway.com
41
12
Hold the new or replacement module at a 30-degree angle and press it
into the empty memory slot. This module is keyed so it can only be
inserted in one direction. If the module does not fit, make sure that the
notch in the module lines up with the tab in the memory bay.
13
Replace the memory bay cover, then tighten the cover screws.
Tips & Tricks
The screw hole is marked with a K.
14
Replace the keyboard screw.
15
Insert the battery(ies), then turn your notebook over.
16
Connect the optional port replicator.
-OR-
Connect the power adapter, modem cable, and network cable.
Replacing the hard drive kit
Tools Required
You need a small Phillips screwdriver to
replace the hard drive kit.
If you would like more hard drive capacity, you can replace your original drive
with a higher-capacity drive.
To replace the hard drive kit:
1
Create a Drivers and Applications Recovery disc. For more information, see
“Creating Drivers and Applications Recovery discs” in the online User
Guide .
2
Print the “Recovering Your System” chapter from the online User Guide for
use in Step 21 .
3
Back up any data you want to transfer to the new hard drive. For more
information, see “Backing up files” in the online
User Guide .
4
Follow the guidelines under “Preventing static electricity discharge” on
page 38 .
5
Turn off your notebook.
Hard drive kit