Gateway E4610D, Reference Manual

Page: 63 / 134

www.gateway.com
57
4
Slide the power supply away from the back of the
computer, then pull it down and remove it.
5
Install the new power supply into the case, then install
the three screws to secure the power supply to the case.
6
Reconnect the power supply cables using your notes
from Step
2 .
7
Replace the side panel, then return the computer to an
upright position.
8
Reconnect all external cables and the power cord.
Replacing the system board
To replace the system board:
1
Remove the side panel by following the instructions in
“Opening and closing the case” on page 37 .
2
Remove all expansion cards by following the directions
in
“Adding or replacing an expansion card” on page 47 .
3
Remove the front fan by following the directions in
“Replacing the front fan” on page 49 .
4
Remove the memory from your computer by following
the directions in
“Installing memory” on page 41 .
5
Disconnect the power and data cables from the system
board, noting their locations and orientation. (You will
reconnect the cables after you install the new board.)
6
Remove the power supply by following the directions in
“Replacing the power supply” on page 56 .
8512735.book Page 57 Thursday, September 27, 2007 1:03 PM