Gateway E-9525R, User Manual

Page: 60 / 130

CHAPTER 4: Installing Components www.gateway.com
54
Replacing the hot-swap backplane
Caution
The hot-swap backplane is not
hot-swappable. Before removing or
replacing the backplane, you must first
turn off the server and all peripheral
devices attached to the server, and
remove the AC power cord(s) from the
power supply or wall outlet.
To replace the hot-swap backplane:
1
Follow the instructions in “Preventing static electricity discharge” on
page 30 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Unlock the bezel (if necessary) and remove it by pulling it straight off the
front of the server.
3
Follow the instructions in “Opening the server case” on page 31 .
4
Remove all of the hot-swap drive carriers from the server and make note
of which bay you remove each drive from. For instructions, see
“Removing
and installing a hard drive” on page 37 .
5
Remove the system fans and fan duct by following the instructions in
“Replacing system fans” on page 46 .
6
Disconnect all cables from the backplane.
7
Pull the backplane bracket and backplane (1) out of the chassis.
Caution
Pressing or pulling on any components
on the backplane could result in damage
to the backplane.
Caution
Make sure you do not pinch, bind, or
damage any cables as you install the
backplane.
8
Press the release tab (2) on the backplane bracket and push the backplane
to the left (3).
9
Pull the backplane from the backplane bracket.