Gateway E-9425R, User Manual

Page: 51 / 128

Installing and removing PCI expansion cards www.gateway.com
45
8
Press the retaining clip (7) holding the riser card in the riser card assembly,
then push the riser card (8) in the direction shown to unlock and remove it.
9
Insert the new riser card into the riser card assembly, then push it toward
the back of the assembly. It should snap into place.
10
Insert the new PCI card into the riser card, making sure any connectors
extend through the slot at the back of the assembly and that the card is
fully seated in the riser card.
11
Close the lock to hold the card in place, then replace the screw that holds
the lock closed.
12
Position the PCI riser assembly over the PCI sockets on the server board,
Then press the PCI riser assembly into the PCI sockets.
13
Follow the instructions in “Closing the server case” on page 32 .
14
See the card’s documentation for software installation instructions.