Gateway ALR 9250R, User Manual

Page: 22 / 226

8 Gateway ALR 9250R User’s Guide
Installing the CPU drawer in the rack
These procedures assume that the mounting rails have not been installed on
the drawer at the factory and that the brackets have not been installed in the
rack. If these procedures have been completed, you can skip them.
Installing the mounting rails
The mounting rails are provided in the accessory kit. If they have already
been installed on the system drawer, you can skip this procedure.
1. After unpacking the system drawer, note that the side rails come
preassembled with the mounting rails. Prior to mounting the side rails
to the system chassis, they must be removed from the mounting rails.
Remove the side rails from the mounting rails by depressing the
retention clips and sliding them off.
2. Mount the side rails on the system chassis with the twelve screws
provided. See the illustration Mounting the Side Rails below. The
retention clips should go toward the rear of the cabinet.
Mounting the Side Rails
To install the mounting rails
9250r_08
Retention clips
9250R.book Page 8 Friday, April 9, 1999 9:44 AM