MANUAL
eGate Smart Building Innovation
www.e-gate.io
Maintenance
Checking the status
Press the button to check the status of the eGate-Kombi-LWUS. The led located next to the micro USB socket will indicate
the status:
•
If the led blinks green, everything is fine, and the remaining battery capacity is estimated to be over 20%.
•
If the led blinks red, the remaining battery capacity is estimated to be below 20%.
•
If the led does not blink at all, the device isn’t working properly
Replacing the batteries
Replace the batteries by following these steps:
•
-RHT-IP42 model: Remove the four screws holding the outer enclosure cover in place.
•
Remove the device from the holder by pushing it upwards.
•
Remove the two PZ1 screws and open the cover.
•
Replace the batteries with 3 new LR6 (alkaline AA) batteries observing the polarity. Avoid touching the electronics.
•
Reassemble the device.
Cleaning
If there is visible dust inside the device, blow it away with pressurized air while avoiding too strong pressure. The enclosure
exterior can be wiped with a damp cloth, but no drop of liquid must enter the device.
5
