AMFIBI XL
GATERD.SE
6
9. System calibration
If power is cut during operation or in direct connection with operations (within
5 seconds of the chair’s having been manoeuvred) it may be necessary to
reset/recalibrate the system. This is done to synchronize the actuator proximity
sensors.
Calibration:
Press both of the remote control buttons UP/DOWN simultaneously for around 10
seconds until a beep is heard. Release the buttons. Press the the DOWN button
and run the chair to its lowest position. Release the button. The system confirms
the action with a buzzer. The system may then be used normally.
10. Battery installation/removal
The battery is usually located in the control box and is held in place magnetically.
Battery removal: Twist the battery 90° – pull it out.
Installation: Slide the battery into the control box (figure 9). The battery is locked
into position magnetically followed by a beep to signal everything is OK.
Audible warnings when battery is installed:
2 long buzzes means calibration must be carried out (see above).
5 short buzzes means the battery must be recharged before operations.
11. Charging the battery
Remove the battery from the control box and place it in the charger supplied.
Connect the charger to the mains (red lamp lights up – charging). When the
battery is fully charged the green lamp lights up.
NOTE: Battery charging must always take place in dry spaces. The
chair may NOT be used when the battery is removed – water may enter
the control box and damage it.
12. Maintenance
The chair is fabricated from steel tubes (painted externally/internally) and
aluminium. Exposed parts that are not painted are made of aluminium/stainless
steel. The chair is cleaned in the normal manner (autoclave proof to 60 degrees
(does not apply to control box and battery) and normal detergents).
9
