After approximately 1½ minutes of frothing, or when Frothing Pitcher
begins to feel warm to touch, press down on Flavor Hatch so that it
opens fully and pouring channel is exposed. Pour desired amount of
flavoring into Pitcher. Push back end of Flavor Hatch forward and down
to close.
Note:
As a safety feature, the Milk Frother cannot be restarted immedi-
ately after reaching its shut off temperature. Either pour cold water into
Pitcher or wait a few minutes until unit has reached a safe temperature.
If you prepare more froth than you require and the remaining froth in
the Pitcher has lost some of its richness, or the froth temperature has
declined, you may refresh the froth to its original richness and
temperature by simply pressing the ON switch.
7. Allow about 30 - 60 seconds for the hot milk to settle. Then, unplug
the power cord, and using the spout, carefully pour the desired amount
of hot milk for Cappuccinos, Lattes or other specialty drinks.
Remember that liquid milk heats to a higher temperature than froth. When
serving to
children, wait until the hot milk cools slightly or stop unit early by
pressing the OFF switch.
8. Remove Lid from Frothing Pitcher, place Lid upside down on the counter to minimize any
milk spillage, and spoon out the rich froth.
Note:
After use, clean your appliance following the ´Care and Cleaning´ instructions.
Between consecutive cycles, the unit must be rinsed with COLD water. To help cool Pitcher,
allow cold water to remain in Pitcher for a few minutes.
After 4 consecutive cycles, unit must be shut off for approximately 10 minutes.
Caution:
Only liquids or powdered mixes can be used. Solid food items must not be used
while unit is operating as they may cause damage to the Froth Whip.
Care and Cleaning
Before first use and after each use, it is important that you clean your Milk Frother following
the guidelines below. You should rinse Pitcher in
cold
water between consecutive cycles.
•
ALWAYS UNPLUG POWER CORD FROM UNIT PRIOR TO CLEANING AND
NEVER IMMERSE IN WATER.
• To allow Froth Whip to be thoroughly cleaned, remove Lid from Frothing Pitcher and
hold Lid with Whip facing upward. Remove Whip and Whip Holder by firmly grasping
Whip Holder and pulling outward and away from Lid. You may also remove Whip from
Whip Holder by securely grasping Whip Holder with your thumb and pointer finger and
turning Whip counterclockwise one quarter turn.
24