Gastro GPOE430DN, Manual

Page: 11 / 22

11
PIZZA OVEN (GAS)
Kasap Tip Dik Buzdolapları
Note: The file with the extension "GGM_PIZZA.hex" must be in the USB memory main
folder. It should not be in a different folder.
• P01: Returns operating settings and parameter values to factory default values. When
the parameter value is "1", pressing the button returns the device to factory values.
When it is "0" it is ineffective.

P02: Determines whether the lamp will turn off automatically after a certain period of time
when the button is touched. When it is "1" it turns off automatically, when it is "0" it does
not turn off automatically.
• P03: When the lamp auto-off parameter (P01) is “1”, it determines after how many
seconds the lamp will turn off.
• P04: It determines the hysteresis value.
• P05: It determines the maximum value of the upper temperature that the user can set as
the set value.
• P06: It determines the maximum value of the lower temperature that the user can set as
the set value.
• P07: It determines the maximum minute value that the user can set as the set time.
• P08: It determines how many seconds the device will give a warning after the cooking
time has expired.
• P09: It determines whether to display or hide when the measured temperature value is
higher than the set value. When the parameter value is "1", the temperature exceeding is
hidden. When it is "0", the measured temperature value is displayed directly.

P10: It determines whether the buzzer will be active or not in the control panel. When it is
"1", the buzzer may sound, when it is "0", the control panel works in silent mode.

P11:
Cihaz turbo konuma alındığı zaman kaç saniye boyunca turbo konumda kalacağını
belirler.
• P12: The working position of the device is determined. If the parameter value is
"0", it works as electrical model, if "1" it works as gas model.

P13: It determines after how many seconds after the reset operation, if the alarm comes
back to the device, gas alarm will be accepted.

P14: It determines after how many minutes the device will turn off again when no button is
touched when the device is turned on with automatic operation mode.

P15: Determining the thermocouple type that the device will measure temperature (0 = J, 1
= K).