background image

7

6

•  Heater must not be located immediately below a 

socket outlet.

•  Heater must not be located in front of a socket 

outlet.

IMPORTANT

POSITIONING THE HEATER

The heater should only be operated at the minimum 
distances noted in Figure 2 on page 5.

Note: This heater is a 15AMP electric heater. This 
requires a special 15AMP power socket to be 
installed by a qualified electrician before being able 
to use.

TO OPERATE

1.  Plug into 15AMP power point.
2.  To turn on - Switch on at the power point.
3.  To tun off - Switch off at the power point. Unplug lead 

from power point when not in use.

IMPORTANT: Turn off the heater. Switch off the power 
switch and disconnect the heater from the power socket.

Always ensure that the heater has been left for one (1)
hour to cool before cleaning.
•   Turn off and disconnect from mains power, allow the  

cool.

•   Wipe unit over with a damp, clean, soft lint-free cloth.
•   For stubborn marks you can use a mild dish washing 

solution on a damp, clean, soft lint-free cloth.

NEVER use solvents, e.g. Petrol, Toluene, Methylated
Spirits etc to clean the heater, as these will damage the
surface finish and may cause a fire when unit is next
used.
•  DO NOT spray with liquids or submerge in liquids or 

water.

•  DO NOT allow water or mild dish washing solution to 

enter or drip onto the heater.

•  DO NOT attempt to clean the interior of the heater.
•  DO NOT attempt to open the heater casing at any 

time.

Gasmate

®

 is a registered trademark of:  

Sitro Group Australia Pty Ltd  

www.gasmate.com.au 

 

Aber Living, Hamilton, N.Z.  

www.gasmate.co.nz

CLEANING AND CARE

OPERATING INSTRUCTIONS

Summary of Contents for Radion GM135-040









Reviews: