Gasmate LANTOS GM174-155, Manual, Page: 14 / 20

15 14
LIGHTING PROCEDURE
Before lighting your barbecue for the first time, read the
instructions fully to ensure the barbecue is assembled
correctly and is ready for use.
Remove all point-of-sale material from the barbecue.
Burner Operation & Ignition System Check
1. Open the hood of the barbecue before attempting to
light the burners.
2. Turn all the control knobs clockwise to “OFF” position.
3. With cylinder valve in “OFF” position turn a control
knob anti-clockwise to “HIGH” (a single click is
heard). Check for sparking to the burner.
4. If spark is not evident at the burner ignition point,
check that the ignition lead is firmly attached to the
control and sparker tip.
5. With sparking established turn the cylinder valve ‘ON’.
6. Push down and turn the control knob anti-clockwise
to “HIGH” again. This will light the burner. Observe if
the burner has lit. If not, repeat this process.
7. If the burner fails to ignite after several attempts turn
off gas supply at cylinder valve and the control knob
off (clockwise). Wait five minutes before attempting
to relight with ignition sequence.
8. Following successful ignition, light the remaining
burners in sequence, turn control knobs anti-
clockwise to ‘HIGH’ starting with the burner closest
to the ignition burner.
9. Adjust the heat by turning each control knob to the
‘HIGH’/’LOW’ position.
10. To turn the barbecue ‘OFF’ turn the cylinder valve
to the ‘OFF’ position, then turn the control knobs on
the barbecue clockwise to the ‘OFF’ position.
Side Burner
1. Lift up the hood or side burner cover (ensure it is
always open when the burner is alight).
2. Push and turn the control knob anti-clockwise to
HIGH (a single click is heard). This will light the
burner. Observe if the burner has lit. If not, repeat
this process.
3. If the burner fails to light after several attempts turn
the control knob to ‘OFF’ and wait a few minutes
before attempting re-ignition.
IMPORTANT:
• Note: If for some reason, ignitor fails to produce
a spark at the electrode, barbecue can be lit by
a long barbecue match. With hood open insert
lighted match into match lighting hole positioned
on the side of the BBQ body. Push and turn a
control knob to ‘HIGH’. Burner ignition can be
checked through this hole.
• Check performance of burner prior to installing
BBQ plates.
• Do not smoke when attempting to ignite BBQ.
• Never use volcanic rock, heat beads or other
material.
• Always use protective gloves when handling hot
components.