10
OPERATION
LIGHTING INSTRUcTIONS
Step 1
Ensure that the control knob is OFF. Slowly open
the gas cylinder valve.
Step 2
Press and turn the control knob to LIGHT position,
push the igniter to generate spark while keeping
control knob pressed in.
Step 3
Check for the pilot flame through glass tube.
If pilot does not light, turn control knob to OFF
position, wait two minutes minimum and try
again. Several attempts may be necessary.
Step 4
If the pilots alight, keep the control knob pressed
for 15 seconds then turn the control knob to LOW.
Step 5
For maximum heat turn control knob to HIGH.
Step 6
To turn heater off, turn the control knob to OFF.
Step 7
Close the valve of the gas cylinder clockwise to
OFF after use.
Connect the
hose to the hose
connector on the
underside of the
control box.
Insert a ‘AA’ battery
with the ‘+’ facing
outwards.
• Never use the heater while it is raining, the glass tube will break.
• The glass tube will be extremely hot when operating, never try to touch it and keep children away
from the heater.
• Always ensure the heater is seated firmly, the glass tube may break if the heater falls.
• Never use the heater if the glass tube has any crack or damage.
• THE GUARD IS FITTED TO THIS APPLIANCE TO REDUCE THE RISK OF FIRE OR INJURY FROM
BURNS AND NO PART OF IT SHOULD BE REMOVED.
• ANY GUARD OR OTHER PROTECTIVE DEVICE REMOVED FOR SERVICING THE APPLIANCE MUST BE
REPLACED PRIOR TO OPERATING THE APPLIANCE.
WARNING
