2
3
Gas Installation Codes
• Appliances must be used in accordance with the
installation requirements of your gas supply
authority, or the Australian Standard AS 5601.
• Appliances for use with bottled gas are labelled
‘propane gas’.
Clearances
Minimum Clearances from combustible materials
must be:
Rear - 180mm Above - 600mm
Hose & Regulator Safety
The regulator and hose assembly supplied with the
appliance are suitable for propane gas only.
A gas regulator adjusted to have an outlet
pressure of 2.75kPA is supplied for connection to
the propane gas cylinder. The pressure regulator
and hose assembly supplied with the appliance
must be used. Replacement pressure regulators
and hose assemblies must be those specified by
the appliance manufacturer.
When connecting the hose and regulator assembly
to the gas cylinder, take care to avoid unnecessary
twisting or kinking of the flexible hose.
After the assembly has been secured, turn on the
gas and check for leaks by brushing a soap and
water solution over all connections.
If you are unable to correct the leak by tightening
the connections, turn off the gas and contact the
supplier immediately.
Always ensure the appliance is kept away from
flammable materials and the gas cylinder clear
of any heat source. When changing over from
an empty gas cylinder to a full one make sure
this procedure is carried out in a well-ventilated
location, preferably outside away from people and
any sources of ignition, such as naked flames,
pilot flames, electric heaters/equipment.
Specifications
Specifications can be found on the data label
attached to the body. Hose connection thread is
GENERAL INFORMATION
3/8” BSP.
Gas Cylinder Use & Safety
This appliance shall only be used with a propane
gas cylinder certified to AS2469.
IT MAY BE HAZARDOUS TO ATTEMPT TO FIT
OTHER TYPES OF GAS CONTAINERS.
Gas cylinders should be stored outdoors in a well
ventilated area out of reach of children. Any indoor
storage shall comply with AS/NZS 1596.
Only use the hose assembly as supplied with this
appliance for connection to the cylinder - DO NOT
USE ADAPTORS.
Maximum hose length is 100cm.
After use, turn the gas cylinder valve off, wait for
the flame to go out, and then turn the appliance
control valve(s) off.
Avoid twisting or kinking the flexible hose.
If there is a leak on your appliance (smell of gas)
immediately attempt to turn off the cylinder valve.
Remove the appliance to a well ventilated location
away from any ignition source. Check for leaks
using soapy water. Do not try to detect leaks using
a flame.
If you store your appliance indoors, ALWAYS
disconnect the cylinder first and store it safely
outside. Cylinders must be stored outdoors in a
well ventilated area out of reach of children, and
must not be stored in a building, garage or any
other enclosed area.
Location of your Appliance
DO NOT use your appliance in garages, porches,
sheds, breezeways, or other enclosed areas. Your
barbecue is to be used OUTDOORS. The appliance
is not intended to be installed in or on recreational
vehicles and/or boats and should not be placed
under any surface that will burn. Do not obstruct
the flow of combustion and ventilation air around
the outer housing.
Protect Children
Keep children away during use and until appliance
has cooled after you have finished. Do not allow
children to operate appliance.
Always ensure that no sporting or physical
activities are carried out in close proximity to the
appliance during use and while still hot.
