Gasmate Callisto Series, Instructions Manual

Page: 15 / 20

14 15
LIGHTING PROCEDURE
Before lighting your barbecue for the first time, read the
instructions fully to ensure the barbecue is assembled
correctly and is ready for use.
Burner Operation & Ignition System Check
1. Open the hood of the barbecue before attempting to
light the burners.
2. Turn all the control knobs clockwise to “OFF” position.
3. With cylinder valve in ‘CLOSE’ position press the piezo
igniter button (a single click is heard). Check for
sparking to the burners.
4. If spark is not evident at the burner ignition point,
check that the ignition lead is firmly attached to the
control and sparker tip.
5. With sparking established turn the cylinder valve to
‘OPEN’.
6. Push and turn control knob anti-clockwise to ‘HIGH’
and press the igniter button again.
7. If the burner fails to ignite after several attempts turn
off gas supply at cylinder valve and the control knob
off (clockwise). Wait five minutes before attempting to
relight with ignition sequence.
8. Following successful ignition, to ignite remaining
burners, turn control knobs to the HIGH position
starting with the burner closest to the ignition burner.
9. Adjust the heat by turning each control knob to the
“HIGH”/”LOW” position.
10. To turn the barbecue ‘OFF’ turn the cylinder valve to
the ‘CLOSE’ position, then turn the control knobs on
the barbecue clockwise to the ‘OFF’ position.
Side Burner
1. Lift up the cover and ensure it is always open when
the burner is alight.
2. Push and turn the control knob anti-clockwise to HIGH
whilst pressing the piezo ignitor (a single click is
heard). This will light the side burner. Observe if the
burner has lit. If not, repeat this process.
3. If the burner fails to light after several attempts turn
the control knob to OFF and wait a few minutes before
attempting re-ignition.
IMPORTANT:
• Note: If for some reason, ignitor fails to produce
a spark at the electrode, barbecue can be lit by
a long barbecue match. With hood open insert
lighted match into match lighting hole positioned
on the side of the BBQ body. Push and turn
a control knob to ‘HIGH’. Burner ignition can
be checked through this hole. Light remaining
burners by cross-lighting.
• Check performance of burner prior to installing
BBQ plates.
• Do not smoke when attempting to ignite BBQ.
• Never use volcanic rock, heat beads or other
material.
• Always use protective gloves when handling hot
components.