5
WARNING
• Don’t put the appliance in direct sunlight.
• Don’t put the appliance near stoves, fires or heaters.
• The appliance shall not be exposed to rain.
• Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of
obstruction. Do not use mechanical devices or
other means to accelerate the defrosting process.
• Do not use electrical appliance inside the food
storage compartments of the appliance.
Protection from Moisture
Avoiding placing the refrigerator in a place where heavy
moisture is present so as to minimise possibility of rusting
of metal parts. The refrigerator should be kept out of
water or direct sprayed water, failure to do this could
cause poor performance and/or an electrical short could
occur.
Protection from Heat
The refrigerator should be protected from excessive heat
sources and out of direct sunlight.
Protect from Cold
The bar fridge should be protected from excessive
cold weather and frosts. Suggested minimum ambient
temperature should ideally be higher than 8°C, so that
optimal performance is not affected.
Moving
When fixed or moved, the refrigerator cannot be set
horizontally or reclined to more than 45° or positioned
upside down.
Never move while refrigerator is plugged in and
operating.
Once you have moved the refrigerator, leave standing in a
level position for 4 - 6 hours so that the gas can settle.
• If power cord is damaged, it must be replaced by
the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard. The
appliance is not to be used if the power cord is
damaged.
• The electrical system of this refrigerator must be
connected with an automatic 30mA circuit breaker
and/or residual current device (RCD). If uncertain
have a qualified electrician check your electrical
system before installation and/or use.
Positioning
Ensure the sides and top have at least 50mm clearance
and the rear at least 50mm clearance to ensure adequate
ventilation.
Never cover the bottom front grill as this is required for
ventilation.
After installation the appliance should be left for 24 hours
before it is plugged in and switched on this is to allow the
refrigerant to settle.
Disposal of Packaging
Always recycle and dispose of all packaging materials in
an environmentally friendly way. For specific information
on recycling in your area contact your local Council
Recycling Centre.
Disposal of Old Appliances
The majority of components are recyclable, however
there are also dangerous chemicals inside. To dispose of
old fridges first remove the doors and contact your local
council for recycling options.
Electrical Installation
The electrical system of this refrigerator must be supplied
through an earthed (3 pin) circuit with a residual current
device (RCD) having a rated residual operating current not
exceeding 30 mA. If uncertain have a qualified electrician
check your electrical system before installation and/or
use.
