4
Tools Required
Phillips head screwdriver, 2 Adjustable spanners
Note: Remove any transit protection material
STEP 1
Attach the brackets onto the base with four M8 x 16mm
bolts, then attach the cylinder cover with eight M5 x 10mm
screws and nuts.
STEP 2
Place the burner head on the cylinder cover and secure
with four M4 x 8mm screws.
STEP 3
Position the mesh guard around the burner with the lift up
door in front of the control knob locating the wire pins into
the cylinder cover holes then secure with the wing nut on
top.
STEP 4
Attach the hose and regulator to the underside of the
burner head, tightening the hose fitting thread firmly. Leak
test this connection with a soapy water solution before
attempting to light the heater.
AREA HEATER ASSEMBLY
BRACKETS
BASE
WING NUT
BURNER HEAD
CYLINDER
COVER
HOSE AND
REGULATOR
MESH GUARD
PARTS LIST
NAME
QTY
Mesh Guard
2
Burner Head
1
Cylinder Cover
1
Hose and Regulator
1
Base
1
Base Brackets
4
Wing Nut
1
M8 x 16mm Bolt
6
M8 Nut
2
M5 x 10mm Screws & Nuts
8
M4 x 8mm Screws
4
