IMPORTANT
Storage of an appliance indoors with the cylinder
attached is only permitted if the size of the cylinder
complies with AS/NZS 1596; otherwise cylinders must
be stored outdoors in a well ventilated area.
The guards are fitted to this appliance to reduce the risk
of fire or injury from burns and no part of it should be
removed.
This appliance must be protected from exposure to rain.
Any modification to the heater not described in the
installation instructions may compromise the safety of this
appliance. Special concern is as follows:
(1)
DO NOT
bypass thermocouple safety burner;
(2)
DO NOT
operate heater without the guard;
Clothing or other flammable materials should not be hung
from the heater, or placed on or near the heater. The area
above the burner may be extremely hot. Direct contact with
these metal surfaces should be avoided in order to prevent
burns or clothing ignition.
Screw the coupling nut of regulator into the cylinder valve
outlet.
QCC CYLINDER CONNECTION DEVICE
Type of Gas
LPG/ULPG
Consumption
36 MJ/h
Operating Pressure
2.75 kPa
Injector Size
1.6 mm
Heater specifications can be found on the data label.
Screw the coupling nut of regulator into the cylinder valve outlet.
Q.C.C. CYLINDER CONNECTION DEVICE
6. The appliance must be inspected before each use, and at
least annually by a qualified service person.
a. The appliance area must be kept clear and free of
combustible materials, gasoline and other flammable
vapours and liquids.
b. Gas orifices and burner must be kept clear of dirt and
cobwebs. Flow of combustion and ventilation air through
the perforated portions of the heater must not be
obstructed. Cleaning with a soft brush before use and at
least every six months is recommended.
c. All gas connections should be checked for leaks utilising
a soap solution.
NEVER
use a flame for this purpose.
d. The flame pattern should be visually checked whenever
heater is operated. If flames extend beyond surface of
the guard the appliance should be turned off and should
not be operated again until the unit is serviced and or
repaired.
e. Any cleaning agent used on the heater should be of a
non-combustible and non-corrosive nature.
f. The stainless steel emitter normally does not require
cleaning and should
NEVER
be painted.
7. The hose must be protected from contact with hot or
sharp surfaces both during use and while in storage. The
hose assembly should be visually inspected prior to each
use of the heater. If excessive abrasion or wear is evident,
or the hose is cut, it must be replaced prior to operating
the heater. The replacement hose assembly may be
obtained from the manufacturer.
8.
DO NOT
use any pressure regulator or hose assembly
other than those supplied with the appliance.
Replacement pressure regulator and hose assembly must
be those specified. Replacement parts maybe obtained
from the manufacturer or your local sales
representative.
9. Installation and use of this heater must conform with New
Zealand Standard 5601 “Gas Installations”.
10. This heater is designed to operate with a standard 9kg
LPG cylinder with Approved Cylinder Connection.
11. The valve outlet must be maintained in good condition.
When the cylinder is not in use, be sure to cover it with
a dust cap. A leak test should be performed with soapy
water whenever connecting a new cylinder.
NEVER
use a
match to test for leaks.
12. The LPG cylinder must be turned off whenever the heater
is not in use. When the heater is to be stored indoors, the
propane cylinder and the heater must be disconnected
and the cylinder stored in accordance with the Standard
for Storage and Handling of Liquefied Gases.
13. The appliance has been designed with several safety
features which include a tip over switch.
