6
TEST FIRING HEATER
Test fire heater, following the lighting instructions. Leak test all gas connections with soapy water. Soap bubbles
indicate gas leakage. DO NOT use a match to test for gas leaks.
TROUBLE SHOOTING
Problem
Possible Causes
Solution
Main burner will
not light
No gas
Replace cylinder
Low gas pressure
Replace cylinder
Blockage in orifice
Remove blockage
Manual valve no in LOW or HIGH position
Position to HIGH
Exposure to rain
Remove emitter and clean burner ports
Note: If the appliance cannot be adjusted to perform correctly it should not be used until serviced or repaired.
White smoke may appear around the emitter grid during the first minute of initial firing.
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.
Any modifications or adjustments made to product without prior authority from the manufacturer will void any
warranty claims. Read the installation, operating and maintenance instructions thoroughly before installing or
servicing this equipment.
WARNING
LIGHTING INSTRUCTIONS
1. Ensure that the control knob is off. Slowly open the
gas cylinder valve.
2. Push in control knob and turn anti-clockwise to
LO whilst simultaneously pressing the red ignitor
button.
3. Check for flame at the burner. If burner does not
light immediately turn control knob to OFF position
and try again from the start. Allow 30 seconds
between ignition attempts for gas to dissipate.
Several attempts may be necessary.
Failure to follow this lighting procedure may result
in flame roll out beyond the emitter grid.
4. With the burner alight keep control knob depressed
for 15 seconds.
5. For maximum heat push in and turn the control
knob to HI.
6. To turn heater off, turn the control knob to OFF.
LO
HI
OFF
