Page 7-36
MDE-4334C Atlas Start-up and Service Manual · April 2008
Hydraulic/Mechanical Components
Meters
Removing/Replacing LC Meters
Note: This meter is used on Ultra-Hi models only.
To remove/replace the LC meter, proceed as follows:
1
Follow steps
in
2
Disconnect the pulser.
3
Remove four bolts from the discharge casting.
4
Remove four bolts on the inlet.
Note: Support the meter while removing bolts.
5
Remove the meter.
6
Perform the necessary service on the meter.
7
Inspect and clean the inlet and discharge line mounting surfaces.
8
Install the new inlet and discharge gaskets.
9
Replace the meter.
10
Bolt the meter to the inlet.
11
Bolt the meter to the discharge casting.
12
Reconnect the pulser.
13
Follow the steps in
.