8
HOW TO
INSTALL SPEAKERS
The MAD X2 series uses a single 4 Ohm voice coil. If you want to connect four or more X2
series speakers, you can vary the impedance by altering the wiring configuration to use a
series or parallel setup. The more the merrier!
Before installing your brand new speakers, make sure that you have everything you need.
Have the right tools ready, and make sure that you have the necessary knowledge/skill to
perform the installation properly. Preparation and knowledge is crucial!
It is important to
know the limits of
your amplifier. Be sure
to connect your sound
system with a suitable
impedance to optimize
your sound system.
Make sure to look through the recommended wiring schematics below and choose the
setup that corresponds with the number of speakers in your sound system. Take note of the
impedance stability of your amplifier. Don’t be afraid to consult your local GAS AUDIO
POWER dealer/installer if you have any questions.
Four 4 Ohm speakers
@ 2 Ohm in parallel
Two 4 Ohm speakers
@ 4 Ohm in standard
Four 4 Ohm speakers
@ 8 Ohm in serial
