GAS GAS SM 700 2023, Owner'S Manual

Page: 88 / 128

14 ELECTRICAL SYSTEM
86
V02741-11
Main work
–
Remove bulb socket
1
.
V02743-10
–
Pull position light lamp
2
out of the bulb socket.
–
Insert a new position light lamp in the bulb socket.
Position light (W5W / socket W2.1x9.5d) ( p. 111)
–
Insert the bulb socket in the reflector.
Finishing work
–
Install the headlight mask with the headlight. ( p. 84)
–
Check the headlight setting. ( p. 86)
14.11 Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light
wall and make a marking at the height of the center of the low beam
headlight.
–
Make another mark at a distance
B
under the first marking.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically at a distance
A
away from the wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now mounts the motorcycle with luggage and passenger if
applicable.
–
Switch on the low beam.
–
Check the headlight setting.
The light-dark boundary must be exactly on the lower mark-
ing when the motorcycle is ready to be operated with the rider
mounted along with any luggage and a passenger if applicable.
» If the boundary between light and dark does not meet specifica-
tions:
–
Adjust headlight range. ( p. 87)