11 SERVICE WORK ON THE CHASSIS
52
Finishing work
–
Install the air filter.
–
Mount the seat. (
11.27
Removing the main silencer
Warning
Danger of burns
The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
F02991-10
–
Remove screw
1
.
–
Remove screw
2
.
–
Pull off the main silencer from the manifold at sleeve
3
.
11.28
Installing the main silencer
F02991-11
–
Position the main silencer.
–
Mount the main silencer with sleeve
1
.
–
Mount the silent block with screw
2
.
Guideline
Remaining screws,
chassis
M6
10 Nm (7.4 lbf ft)
–
Position the collar bushings.
–
Mount and tighten screw
3
.
Guideline
Remaining screws,
chassis
M6
10 Nm (7.4 lbf ft)
11.29
Changing the glass fiber yarn filling of the main silencer
Warning
Danger of burns
The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn escape and the damper “burns” out.
Not only is the noise level higher, but the performance characteristics change.
Preparatory work
–
Remove main silencer. (
