ELECTRICAL SYSTEM 14
93
14.1
Removing the 12-V battery
Caution
Danger of burns
The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
Note
Environmental hazard
12 V batteries contain environmentally hazardous materials.
–
Do not dispose of 12 V batteries as household waste.
–
Dispose of 12 V batteries at a collection point for used batteries.
Preparatory work
–
Remove the seat. (
F00138-10
Main work
–
Hang the voltage regulator to the side.
–
Disconnect negative cable
1
from the 12-V battery.
–
Pull back positive terminal cover
2
and disconnect the positive
cable from the 12-V battery.
–
Remove screw
3
.
–
Pull holding bracket
4
forward and remove the 12-V battery
upwards.
14.2
Installing the 12-V battery
H00386-10
Main work
–
Insert the 12 V battery into the battery compartment with the ter-
minals facing forward and secure with holding bracket
1
.
12-V battery (HJTZ5S-FP-C) (
–
Mount and tighten screw
2
.
Guideline
Remaining screws,
chassis
M6
10 Nm (7.4 lbf ft)
–
Connect positive cable
3
to the 12-V battery.
Guideline
Screw, battery terminal M5
2.5 Nm (1.84 lbf ft)
–
Connect negative cable
4
to the 12-V battery.
Guideline
Screw, battery terminal M5
2.5 Nm (1.84 lbf ft)
Contact disks
A
must be mounted under screws
5
and cable
sockets
6
with the claws toward the battery terminal.
–
Slide positive terminal cover
7
over the positive terminal.
–
Position the voltage regulator.
Finishing work
–
Mount the seat. (
