GAS GAS MC 350F 2023, Owner'S Manual

Page: 53 / 143

SERVICE WORK ON THE CHASSIS 11
51
H01167-01
Main work
–
Move the handlebar to the straight-ahead position. Move the fork
legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
» If there is detectable play:
–
Adjust the steering head bearing play. ( p. 51)
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the entire
steering range. There should be no detectable detent positions.
» If detent positions are detected:
–
Adjust the steering head bearing play. ( p. 51)
–
Check the steering head bearing and adjust if necessary.
–
Check the steering stop bolts for correct adjustment and locking.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 44)
11.12 Adjusting the steering head bearing play
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 44)
–
Remove the handlebar cushion.
A00807-10
Main work
–
Loosen screws
1
.
–
Remove screw
2
.
–
Loosen and retighten screw
3
.
Guideline
Screw, top steering
head
M20x1.5 12 Nm (8.9 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp to
avoid stresses.
–
Mount and tighten screw
2
.
Guideline
Screw, top triple clamp M8 20 Nm (14.8 lbf ft)
–
Tighten screws
1
.
Guideline
Screw, top triple clamp M8 20 Nm (14.8 lbf ft)
–
Check the steering head bearing for play. ( p. 50)
Finishing work
–
Mount the handlebar cushion.
–
Remove the motorcycle from the lift stand. ( p. 44)