GAS GAS F0001U1, Owner'S Manual

Page: 47 / 104

SERVICE WORK ON THE CHASSIS 13
45
The second milled groove (from the top) is flush with the
upper edge of the upper triple clamp.
M01842-11
–
Tighten screws
2
.
Guideline
Screw, top triple clamp M8 20 Nm (14.8 lbf ft)
–
Tighten screws
3
.
Guideline
Screw, bottom triple
clamp M8 15 Nm (11.1 lbf ft)
M01843-10
–
Position the brake caliper, mount screw
4
, and tighten.
Guideline
Screw, front
brake caliper M8x60 20 Nm (14.8 lbf ft)
Loctite ® 243™
–
Mount and tighten screw
5
.
Guideline
Screw, front
brake caliper M8x40 20 Nm (14.8 lbf ft)
Loctite ® 243™
–
Position the brake line and the clamp. Mount and tighten
screws
6
.
Guideline
Screw, brake line
clamp on fork
protector EJOT PT ®
K60x20
‑
AL
2 Nm (1.5 lbf ft)
Finishing work
–
Install the front wheel. ( p. 73)
13.9 Removing the lower triple clamp
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 42)
–
Remove the front wheel. ( p. 73)
–
Remove the fork legs. ( p. 44)
–
Remove the start number plate. ( p. 49)
–
Remove front fender. ( p. 50)
M01844-10
Main work
–
Remove nut
1
.
–
Remove the cable tie on the magnetic switch cable from the handle-
bar.
–
Release screw
2
, take off the upper triple clamp with the handle-
bar and set aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.