GAS GAS EC 350F, Owner'S Manual

Page: 48 / 150

11 TUNING THE CHASSIS
46
11.14 Handlebar position
F03176-10
On the upper triple clamp, there are 2 holes at a distance of
A
to each
other.
Hole distance
A
15 mm (0.59 in)
The holes on the handlebar supports are placed at a distance of
B
from the center.
Hole distance
B
3.5 mm (0.138 in)
The handlebar supports can be mounted in four different positions.
11.15 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
Preparatory work
–
Remove the handlebar cushion.
F03177-10
Main work
–
Remove screws
1
. Take off the handlebar clamps. Remove the
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
2
. Take off handlebar supports.
–
Place handlebar supports in required position. Mount and tighten
screws
2
.
Guideline
Screw, handlebar
holder M10 40 Nm (29.5 lbf ft)
Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.